APRS Track Direct

My position About ☰

reset

SP8MB-L Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8MB-L. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1836274811	474 Count	0 Count	0 Count
1836274690	473 Count	0 Count	0 Count
1836274569	472 Count	0 Count	0 Count
1836274545	478 Count	0 Count	0 Count
1836274449	471 Count	0 Count	0 Count
1836274424	477 Count	0 Count	0 Count
1836274328	470 Count	0 Count	0 Count
1836274303	476 Count	0 Count	0 Count
1836274207	469 Count	0 Count	0 Count
1836274182	475 Count	0 Count	0 Count
1836274086	468 Count	0 Count	0 Count
1836273965	467 Count	0 Count	0 Count
1762329062	582 Count	67 Count	67 Count
1762328941	581 Count	67 Count	67 Count
1762328821	580 Count	67 Count	67 Count
1762328700	579 Count	67 Count	67 Count
1762328579	578 Count	67 Count	67 Count
1762328458	577 Count	67 Count	67 Count
1762328341	576 Count	67 Count	67 Count
1762328216	575 Count	67 Count	67 Count
1762328095	573 Count	66 Count	66 Count
1762327975	572 Count	66 Count	66 Count
1762327854	571 Count	66 Count	66 Count
1762327733	570 Count	66 Count	66 Count
1762327612	569 Count	66 Count	66 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)