APRS Track Direct

My position About ☰

reset

SR2ZYT-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZYT-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1754152696	576	657	355	419	276
1754150897	574	656	354	419	277
1754149099	572	655	353	419	277
1754147299	570	654	352	419	277
1754145500	568	653	351	419	277
1754143698	567	653	351	419	276
1754141898	566	652	351	419	276
1754140097	564	651	350	418	276
1754138299	561	648	348	419	276
1754136500	559	647	347	419	275
1754134701	556	644	345	419	275
1754132903	553	642	343	419	275
1754131106	552	642	343	419	275
1754129305	551	642	343	419	275
1754127507	550	642	343	421	220
1754125707	548	640	342	421	220
1754123909	547	640	342	420	219
1754122111	546	640	342	419	219
1754120312	545	640	342	419	219
1754119023	544	640	342	418	219
1754116715	543	640	342	418	219
1754114916	542	640	342	417	218
1754113118	541	640	342	417	219
1754111318	540	640	342	417	219
1754107720	538	640	342	416	220

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)