APRS Track Direct

My position About ☰

reset

LAGRND Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LAGRND. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786726146	140	21	22	19	39
1786723596	140	21	22	20	39
1786721046	140	21	22	20	39
1786718497	140	21	23	20	39
1786715946	140	21	22	19	39
1786713396	140	21	23	20	39
1786710846	140	21	22	19	39
1786708296	140	21	22	20	39
1786705746	140	21	23	20	39
1786700646	140	21	22	20	39
1786698096	140	21	23	20	39
1786695546	140	21	22	20	39
1786692996	140	21	22	20	39
1786690446	140	21	23	20	39
1786687897	140	21	23	20	39
1786685345	140	21	23	20	39
1786682795	140	21	23	20	39
1786680245	140	21	23	20	39
1786677695	140	21	23	20	39
1786675145	140	21	23	20	39
1786672596	140	21	23	20	39
1786670045	140	21	23	20	40
1786667495	140	21	23	20	39
1786664945	140	21	23	20	39
1786662395	140	21	23	20	42

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)