APRS Track Direct

My position About ☰

reset

VE7RSS Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE7RSS. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1791759356	136	137	73	43	123
1791758216	136	137	73	43	123
1791757076	136	137	73	43	123
1791755936	131	136	72	43	122
1791754796	136	137	73	43	123
1791753656	136	137	73	43	123
1791752516	136	137	73	43	123
1791751376	135	137	73	43	124
1791750236	136	137	73	43	123
1791749096	136	137	72	43	123
1791747956	136	137	73	43	123
1791746816	136	137	72	43	123
1791745676	136	137	72	43	123
1791744536	136	137	72	43	123
1791743396	136	137	72	43	123
1791742256	136	137	72	43	123
1791741117	136	137	72	43	123
1791739976	136	137	72	43	123
1791738836	136	136	72	43	123
1791737696	136	137	72	43	123
1791736555	136	137	72	43	123
1791735416	136	137	72	43	123
1791734276	136	137	72	43	121
1791733135	136	137	72	43	123
1791731995	131	136	72	43	122

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)