APRS Track Direct

My position About ☰

reset

SR2CA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1836274200	21 Count	626 Count	4 Count
1762313622	43 Count	327 Count	26 Count
1762311942	40 Count	306 Count	24 Count
1762310261	37 Count	282 Count	22 Count
1762308580	34 Count	254 Count	20 Count
1762306899	31 Count	228 Count	18 Count
1762305219	28 Count	207 Count	17 Count
1762303795	22 Count	189 Count	15 Count
1762302114	19 Count	163 Count	13 Count
1762300433	16 Count	142 Count	11 Count
1762298752	13 Count	119 Count	9 Count
1762297071	10 Count	91 Count	7 Count
1762295390	8 Count	74 Count	6 Count
1762293709	5 Count	48 Count	4 Count
1762292029	2 Count	25 Count	2 Count
1762290348	171 Count	1012 Count	109 Count
1762288660	168 Count	986 Count	107 Count
1762286979	165 Count	956 Count	105 Count
1762285298	162 Count	936 Count	103 Count
1762283618	159 Count	913 Count	102 Count
1762282186	153 Count	893 Count	100 Count
1762280505	150 Count	867 Count	98 Count
1762278825	146 Count	841 Count	95 Count
1762277144	143 Count	816 Count	93 Count
1762275463	140 Count	795 Count	91 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)