APRS Track Direct

My position About ☰

reset

SP3HUO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3HUO-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1758252440	23 Count	16 Count	15 Count
1758250640	22 Count	16 Count	15 Count
1758248839	21 Count	16 Count	15 Count
1758247038	20 Count	16 Count	15 Count
1758245237	19 Count	16 Count	15 Count
1758243436	18 Count	16 Count	15 Count
1758241635	17 Count	16 Count	15 Count
1758239834	16 Count	16 Count	15 Count
1758238033	15 Count	16 Count	15 Count
1758236232	14 Count	16 Count	15 Count
1758234438	13 Count	16 Count	15 Count
1758232637	12 Count	16 Count	15 Count
1758230836	11 Count	16 Count	15 Count
1758229035	10 Count	16 Count	15 Count
1758227234	9 Count	16 Count	15 Count
1758225433	8 Count	16 Count	15 Count
1758223632	7 Count	16 Count	15 Count
1758221831	6 Count	16 Count	15 Count
1758220031	5 Count	16 Count	15 Count
1758218230	4 Count	16 Count	15 Count
1758216429	3 Count	16 Count	15 Count
1758214628	2 Count	16 Count	15 Count
1758214598	0 Count	16 Count	15 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)