APRS Track Direct

My position About ☰

reset

IZ7SHN-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ7SHN-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1762338038	105	124	255	92	61
1762334431	104	124	255	92	61
1762333530	104	124	255	92	61
1762328121	112	124	255	92	60
1762327221	112	124	255	92	60
1762326318	113	124	255	92	61
1762324512	112	124	255	93	62
1762323605	113	123	255	94	64
1762322699	57	122	255	98	68
1762320897	50	122	255	99	69
1762319996	48	122	255	99	69
1762319095	48	122	255	99	69
1762317293	48	122	255	99	69
1762316392	48	122	255	99	69
1762315491	49	122	255	99	69
1762314590	49	122	255	99	69
1762313689	49	122	255	99	69
1762312788	49	122	255	99	69
1762311882	49	122	255	99	69
1762310981	49	122	255	99	69
1762310079	49	122	255	99	69
1762308271	49	122	255	99	68
1762306470	50	122	255	99	68
1762304668	50	122	255	98	68
1762302866	50	123	255	98	68

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)