APRS Track Direct

My position About ☰

reset

ZL2MTB-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL2MTB-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274444	135	29	999	667	510
1836274366	135	29	999	668	511
1774154001	136	36	999	653	488
1774152802	136	36	999	652	488
1774151603	135	36	999	652	488
1774150404	136	36	999	652	487
1774149205	136	37	999	651	487
1774148006	135	37	999	651	487
1774146807	135	37	999	650	484
1774146672	136	37	999	651	486
1774145473	136	37	999	651	487
1774144274	135	37	999	651	487
1774143075	135	36	999	652	488
1774141876	135	36	999	652	488
1774140677	135	36	999	653	490
1774139478	135	35	999	654	491
1774138279	136	35	999	655	492
1774137080	135	35	999	656	493
1774135880	136	34	999	656	494
1774133482	136	34	999	658	496
1774132283	136	33	999	658	497
1774131084	135	33	999	659	498
1774129885	136	33	999	660	499
1774128686	135	32	999	661	501
1774127487	135	32	999	662	503

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)