APRS Track Direct

My position About ☰

reset

VK7MBD-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK7MBD-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732289108	125	13	255	83	62
1732288207	125	13	255	83	62
1732287304	125	13	255	83	62
1732286403	125	13	255	83	62
1732285501	125	13	255	83	62
1732284599	125	13	255	83	62
1732283697	125	13	255	83	62
1732282796	125	13	255	83	62
1732281894	125	13	255	82	62
1732280992	125	13	255	82	62
1732280091	125	13	255	82	62
1732279189	125	14	255	82	61
1732278288	125	14	255	82	61
1732277386	125	14	255	82	61
1732276485	125	14	255	81	61
1732275583	126	14	255	81	60
1732274681	126	15	255	81	60
1732273780	126	15	255	81	60
1732272878	126	15	255	80	59
1732271977	126	16	255	80	59
1732271075	126	16	255	80	58
1732270174	126	16	255	79	58
1732269272	126	17	255	79	57
1732268371	126	18	255	78	57
1732267469	126	18	255	77	56

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)