APRS Track Direct

My position About ☰

reset

ALDER Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ALDER. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1749329535	218	36	27	22	118
1749329233	218	37	28	22	118
1749328932	218	36	27	22	118
1749328634	218	37	28	22	118
1749328333	218	36	27	22	118
1749328032	218	36	27	22	118
1749327733	218	37	28	22	118
1749327432	218	36	27	22	118
1749327132	219	37	28	22	118
1749326834	218	36	27	22	118
1749326533	218	37	27	22	118
1749326232	231	37	28	22	118
1749325933	231	37	28	22	118
1749325633	225	37	27	22	118
1749325333	231	37	28	22	118
1749325034	231	36	27	22	118
1749324733	231	36	27	22	118
1749324433	231	37	28	22	118
1749324132	231	37	27	22	118
1749323833	231	37	27	22	118
1749323532	230	37	27	22	118
1749323233	231	37	28	22	118
1749322933	231	37	28	22	118
1749322633	230	37	28	22	118
1749322333	227	38	28	22	118

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)