APRS Track Direct

My position About ☰

reset

VE6WRO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE6WRO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786726873	119	144	73	40	122
1786725973	119	144	73	40	122
1786725073	119	144	73	40	122
1786724173	119	144	73	40	122
1786723273	119	144	73	40	122
1786722373	119	143	73	41	122
1786721473	119	143	73	41	123
1786720573	119	143	73	41	122
1786719673	118	143	73	41	122
1786718773	119	143	73	41	122
1786717873	119	143	73	41	122
1786716973	119	143	73	41	123
1786716073	119	143	73	41	122
1786715173	119	143	73	41	122
1786714273	119	143	73	41	122
1786713373	119	143	73	41	122
1786712473	119	143	73	41	122
1786711573	119	143	73	41	122
1786710673	119	143	73	41	123
1786709773	119	143	73	41	123
1786708878	119	143	73	41	123
1786707973	119	143	73	41	123
1786707073	119	143	73	41	123
1786706173	119	143	73	41	123
1786705273	119	143	73	41	123

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)