APRS Track Direct

My position About ☰

reset

PANDO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PANDO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790630296	126	21	93	42	74
1790628490	127	22	64	42	48
1790626688	127	25	66	64	49
1790624885	127	21	65	42	48
1790621281	129	22	66	65	49
1790619476	126	22	66	65	49
1790617674	126	23	66	42	48
1790615871	126	25	66	42	48
1790614071	125	25	65	42	48
1790612264	124	22	66	42	48
1790610462	124	22	66	42	48
1790608658	124	69	66	42	48
1790606855	125	20	65	65	49
1790605052	124	25	65	42	48
1790603250	124	21	65	42	48
1790601447	123	25	66	42	48
1790599644	124	24	67	42	48
1790597840	124	20	93	42	74
1790594235	124	22	65	42	48
1790592431	124	23	95	42	48
1790590627	124	21	66	42	48
1790588824	125	22	95	42	74
1790587021	124	23	94	42	74
1790585219	125	25	66	64	49
1790583416	125	21	93	42	74

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)