APRS Track Direct

My position About ☰

reset

EA1L Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA1L. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value3*	Value4*
1836274195	81	80	185
1782631106	37	83	184
1782629306	38	83	184
1782627506	38	83	185
1782625706	35	83	184
1782623906	37	83	184
1782622107	38	83	185
1782620306	38	83	185
1782618507	38	83	185
1782616706	39	83	185
1782614907	39	83	184
1782613106	41	83	184
1782611307	43	83	185
1782609506	41	83	185
1782607706	40	83	185
1782605906	37	83	185
1782604106	39	83	185
1782602306	40	83	185
1782600507	37	83	185
1782598706	33	83	185
1782596906	27	83	185
1782595107	25	83	184
1782593307	28	83	184
1782591507	34	83	184
1782589707	40	83	185

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)