APRS Track Direct

My position About ☰

reset

ZL4AA-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL4AA-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790650803	138	28	666	40	193
1790650203	138	29	607	41	196
1790649603	138	26	634	40	193
1790649003	139	32	595	47	191
1790648403	138	29	642	41	185
1790647803	138	29	614	41	181
1790647203	138	30	603	42	177
1790646603	138	29	670	42	174
1790646003	138	30	661	44	174
1790645403	138	30	610	44	173
1790644804	138	31	613	45	173
1790644204	139	0	634	1	173
1790643614	140	37	514	53	170
1790643004	144	51	594	76	171
1790642403	142	40	585	64	171
1790641803	144	52	633	78	170
1790641203	144	53	628	79	165
1790640603	144	56	598	82	164
1790640003	144	57	610	83	161
1790639403	144	59	624	88	156
1790638803	139	51	550	70	155
1790638203	139	54	517	78	156
1790637603	135	45	554	64	155
1790637003	135	35	507	48	155
1790636403	139	62	558	88	151

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)