APRS Track Direct

My position About ☰

reset

SR9WXS Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9WXS. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274290	132	16	2	0	100
1782504970	87	6	4	0	100
1782504085	90	11	9	0	100
1782503486	98	8	7	0	100
1782502885	85	7	5	0	100
1782502282	96	8	7	0	100
1782501681	76	6	5	0	100
1782501081	105	9	7	0	100
1782500197	112	8	7	0	100
1782499596	129	12	10	2	100
1782498992	121	19	18	1	100
1782498392	110	16	15	3	100
1782497792	124	17	15	0	100
1782496188	123	18	16	1	100
1782495584	110	18	17	1	100
1782494984	118	10	9	2	100
1782494384	102	20	18	1	100
1782493619	101	24	23	1	100
1782493019	95	17	15	0	100
1782491819	109	22	20	3	100
1782491216	106	17	16	2	100
1782490616	99	17	16	1	100
1782490016	119	20	18	3	100
1782488531	115	25	23	0	100
1782487927	103	25	24	0	100

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)