APRS Track Direct

My position About ☰

reset

WD4ITE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WD4ITE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753580858	918 Count	377 Count	377 Count
1753580257	916 Count	376 Count	376 Count
1753579684	914 Count	375 Count	375 Count
1753579083	913 Count	375 Count	375 Count
1753578483	911 Count	374 Count	374 Count
1753577882	909 Count	373 Count	373 Count
1753577281	908 Count	373 Count	373 Count
1753576682	906 Count	372 Count	372 Count
1753576080	904 Count	371 Count	371 Count
1753575479	903 Count	371 Count	371 Count
1753574878	901 Count	370 Count	370 Count
1753574278	899 Count	369 Count	369 Count
1753573677	898 Count	369 Count	369 Count
1753573076	896 Count	368 Count	368 Count
1753572475	894 Count	367 Count	367 Count
1753571874	893 Count	367 Count	367 Count
1753571273	891 Count	366 Count	366 Count
1753570673	889 Count	365 Count	365 Count
1753570072	888 Count	365 Count	365 Count
1753569471	886 Count	364 Count	364 Count
1753568870	884 Count	363 Count	363 Count
1753568269	883 Count	363 Count	363 Count
1753567669	881 Count	362 Count	362 Count
1753567068	879 Count	361 Count	361 Count
1753566467	878 Count	361 Count	361 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)