APRS Track Direct

My position About ☰

reset

YB2YEN-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YB2YEN-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1770166225	-63 dBm	21 V
1770165920	-61 dBm	21 V
1770165580	-63 dBm	21 V
1770165259	-63 dBm	21 V
1770165086	-62 dBm	21 V
1770164151	-63 dBm	21 V
1770163786	-62 dBm	21 V
1770163443	-62 dBm	21 V
1770163183	-62 dBm	21 V
1770162842	-64 dBm	21 V
1770162795	-61 dBm	21 V
1770162772	-59 dBm	21 V
1770161817	-60 dBm	21 V
1770161494	-58 dBm	21 V
1770160818	-57 dBm	20.92 V
1770160565	-59 dBm	20.84 V
1770160118	-61 dBm	20.43 V
1770159892	-60 dBm	19.5 V
1770159870	-62 dBm	18.72 V
1770159175	-61 dBm	17.29 V
1770158808	-61 dBm	15.83 V
1770158542	-61 dBm	14.38 V
1770158541	-61 dBm	13.19 V
1770157818	-62 dBm	6.77 V
1770157510	-60 dBm	3.73 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)