APRS Track Direct

My position About ☰

reset

NJ7J-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object NJ7J-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790660263	133	76	572	474	387
1790659662	133	76	572	474	387
1790659061	133	76	571	475	388
1790658460	133	77	572	475	387
1790657859	133	77	571	475	387
1790657258	134	77	573	476	387
1790656657	134	77	573	477	386
1790656056	133	77	573	476	386
1790655455	134	77	573	477	386
1790654856	134	78	573	477	386
1790654252	134	77	573	477	387
1790653651	134	76	573	478	389
1790653050	134	77	572	479	389
1790652449	134	77	572	479	389
1790651848	135	78	573	479	388
1790651247	135	78	573	478	388
1790650646	135	77	574	479	389
1790650045	135	77	573	480	389
1790649444	135	79	573	479	388
1790648843	136	78	574	479	388
1790648242	136	78	574	479	388
1790647641	136	79	574	478	387
1790647040	136	79	574	479	386
1790645838	137	80	575	482	386
1790645237	137	81	576	482	386

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)