APRS Track Direct

My position About ☰

reset

VE6RPT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE6RPT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274096	137	149	74	41	123
1782522804	137	151	75	41	123
1782521004	137	151	75	41	123
1782519204	137	152	75	42	123
1782517404	137	151	75	41	123
1782515604	137	151	75	42	123
1782512004	137	151	75	41	123
1782510204	137	150	74	41	123
1782508404	137	151	75	41	123
1782506604	137	152	76	42	123
1782504804	137	151	75	42	123
1782501203	137	152	75	42	123
1782499403	137	152	75	42	123
1782497603	137	151	75	42	123
1782494003	137	151	75	41	123
1782492203	137	150	74	41	123
1782490403	137	151	75	41	123
1782488603	137	151	75	41	123
1782486803	137	152	75	42	123
1782485003	137	152	76	42	123
1782483203	137	151	75	42	123
1782481403	137	149	74	41	123
1782477803	137	147	73	40	123
1782476003	137	146	73	40	123
1782474203	137	146	72	40	123

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)