APRS Track Direct

My position About ☰

reset

F4CVH-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4CVH-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790674886	151	21	999	708	584
1790673184	152	20	999	709	585
1790671478	152	20	999	707	584
1790669776	152	20	999	709	586
1790668074	152	20	999	708	585
1790666371	151	20	999	709	585
1790664667	152	20	998	709	586
1790662965	152	20	999	708	585
1790661263	151	20	999	709	585
1790659558	151	20	999	708	585
1790657855	152	20	999	709	586
1790656155	152	20	999	709	586
1790654454	152	20	999	710	586
1790649348	152	20	999	708	585
1790647646	152	20	999	708	584
1790645944	152	20	998	709	585
1790644241	152	20	999	708	585
1790642541	152	20	999	709	585
1790640838	151	20	999	711	589
1790639136	152	21	999	710	585
1790637430	151	21	999	711	586
1790635729	152	21	999	709	588
1790634025	152	21	999	710	586
1790632320	152	21	999	707	584
1790630618	152	21	999	708	584

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)