APRS Track Direct

My position About ☰

reset

SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1782532592	197 Count	865 Count	50 Count
1782531991	196 Count	850 Count	50 Count
1782530789	193 Count	820 Count	49 Count
1782529588	190 Count	798 Count	48 Count
1782528986	189 Count	776 Count	48 Count
1782527785	185 Count	744 Count	46 Count
1782526583	182 Count	709 Count	45 Count
1782525982	180 Count	697 Count	44 Count
1782524781	178 Count	675 Count	44 Count
1782522978	173 Count	645 Count	42 Count
1782521777	170 Count	625 Count	41 Count
1782519974	163 Count	591 Count	37 Count
1782517600	151 Count	529 Count	33 Count
1782516399	147 Count	498 Count	31 Count
1782515798	144 Count	477 Count	29 Count
1782513995	140 Count	438 Count	28 Count
1782512794	138 Count	424 Count	28 Count
1782510990	134 Count	413 Count	27 Count
1782509789	132 Count	397 Count	27 Count
1782507986	129 Count	388 Count	27 Count
1782506784	127 Count	386 Count	27 Count
1782506183	126 Count	385 Count	27 Count
1782504982	124 Count	383 Count	27 Count
1782503780	122 Count	380 Count	27 Count
1782503180	121 Count	379 Count	27 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)