APRS Track Direct

My position About ☰

reset

KQ6DI-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1758241658	740	419	728	3067	179
1758241358	738	413	727	3067	180
1758241058	736	408	725	3067	179
1758240757	734	408	723	3068	175
1758240458	730	408	718	3069	175
1758240158	723	386	712	3069	175
1758239858	714	365	701	3070	172
1758239557	715	343	691	3070	170
1758239258	726	354	702	3071	169
1758238958	737	408	726	3068	176
1758238658	734	408	723	3068	176
1758238357	730	402	718	3069	174
1758238058	720	386	709	3070	172
1758237758	715	349	694	3071	170
1758237457	723	343	700	3071	170
1758237157	735	376	714	3070	172
1758236858	740	408	727	3069	175
1758236558	736	408	724	3069	174
1758236257	730	402	718	3071	169
1758235958	720	376	709	3071	168
1758235658	717	349	697	3071	166
1758235358	725	354	701	3072	166
1758235057	736	365	714	3070	171
1758234758	749	397	734	3068	176
1758234457	749	429	737	3067	179

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)