APRS Track Direct

My position About ☰

reset

SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1836274471	75 Count	994 Count
1782481415	86 Count	934 Count
1782477821	84 Count	877 Count
1782476020	83 Count	840 Count
1782474219	82 Count	832 Count
1782472418	81 Count	824 Count
1782470618	80 Count	816 Count
1782468817	79 Count	808 Count
1782467016	78 Count	800 Count
1782465216	77 Count	792 Count
1782463415	76 Count	785 Count
1782461614	75 Count	769 Count
1782459814	74 Count	761 Count
1782458013	73 Count	741 Count
1782456219	72 Count	735 Count
1782454419	71 Count	725 Count
1782452618	70 Count	715 Count
1782450817	69 Count	703 Count
1782449017	68 Count	694 Count
1782447216	67 Count	681 Count
1782445415	66 Count	673 Count
1782443615	65 Count	665 Count
1782441814	64 Count	655 Count
1782440014	63 Count	642 Count
1782438213	62 Count	634 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)