APRS Track Direct

My position About ☰

reset

W5AUU-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W5AUU-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value5*
1786723496	132	96	122
1786722890	132	96	122
1786722284	132	95	122
1786721678	132	95	122
1786721071	132	95	122
1786720465	132	94	122
1786719859	132	94	122
1786719253	132	94	122
1786718647	132	94	122
1786718041	132	94	122
1786717436	132	94	122
1786716830	132	93	123
1786716224	132	93	123
1786715618	132	93	123
1786715012	132	93	122
1786714406	132	93	123
1786713800	132	94	123
1786713194	132	94	123
1786712588	132	94	123
1786711982	132	94	123
1786711376	132	94	123
1786710770	132	94	123
1786710164	132	94	123
1786709558	132	94	122
1786708953	132	94	122

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)