APRS Track Direct

My position About ☰

reset

W5AUU-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W5AUU-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value5*
1836274780	138	82	109
1836274174	135	82	109
1766233788	137	51	117
1766233181	137	51	117
1766232575	137	51	117
1766231969	137	52	117
1766231363	137	52	117
1766230757	137	52	117
1766230150	137	53	117
1766229544	137	53	117
1766228938	137	53	117
1766228332	137	53	117
1766227726	137	53	117
1766227120	137	53	117
1766226513	137	53	117
1766225908	137	53	117
1766225301	137	53	117
1766224695	137	53	116
1766224088	137	53	116
1766223482	137	53	117
1766222876	137	53	117
1766222270	137	53	116
1766221664	137	53	116
1766221058	137	54	116
1766220454	137	53	116

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)