APRS Track Direct

My position About ☰

reset

W0ANA-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W0ANA-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1782523794	143	118	999	213	146
1782522892	143	118	999	212	146
1782521980	143	118	999	211	144
1782521078	143	118	999	226	147
1782520172	143	118	999	228	150
1782519271	143	117	999	229	151
1782518369	143	118	999	227	149
1782517467	143	118	999	212	146
1782516565	143	118	999	213	146
1782515661	143	118	999	214	147
1782514758	139	118	999	214	148
1782513857	143	117	999	216	150
1782512955	143	116	999	217	152
1782512049	143	116	999	220	155
1782511147	143	114	999	223	160
1782510241	143	119	999	211	143
1782509339	143	118	999	211	144
1782508434	143	118	999	212	145
1782507529	143	118	999	213	146
1782506621	143	118	999	215	149
1782505718	139	117	999	216	150
1782504815	143	117	999	216	149
1782503913	139	116	999	218	152
1782503010	143	116	999	219	154
1782502108	143	116	999	218	153

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)