APRS Track Direct

My position About ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1836274376	160 Count	128 Count	13 Count
1836274228	162 Count	143 Count	14 Count
1762318964	140 Count	112 Count	10 Count
1762318363	139 Count	108 Count	10 Count
1762317762	138 Count	104 Count	10 Count
1762317161	137 Count	103 Count	10 Count
1762316560	136 Count	101 Count	10 Count
1762315959	135 Count	92 Count	10 Count
1762315358	134 Count	83 Count	10 Count
1762314757	133 Count	83 Count	10 Count
1762314156	132 Count	83 Count	10 Count
1762313555	131 Count	81 Count	10 Count
1762312954	130 Count	79 Count	10 Count
1762312353	129 Count	79 Count	10 Count
1762311752	128 Count	79 Count	10 Count
1762311151	127 Count	79 Count	10 Count
1762310586	126 Count	79 Count	10 Count
1762309985	125 Count	79 Count	10 Count
1762309384	124 Count	79 Count	10 Count
1762308783	123 Count	79 Count	10 Count
1762308182	122 Count	79 Count	10 Count
1762307581	121 Count	79 Count	10 Count
1762306980	120 Count	79 Count	10 Count
1762306379	119 Count	79 Count	10 Count
1762305778	118 Count	79 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)