APRS Track Direct

My position About ☰

reset

SQ2CPA-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790659221	88 Count	163 Count
1790657420	84 Count	159 Count
1790655619	80 Count	155 Count
1790653819	76 Count	147 Count
1790652018	72 Count	139 Count
1790650217	68 Count	132 Count
1790648416	64 Count	125 Count
1790646616	60 Count	118 Count
1790644815	56 Count	106 Count
1790643014	52 Count	100 Count
1790641222	48 Count	95 Count
1790639422	44 Count	91 Count
1790637621	40 Count	87 Count
1790635822	36 Count	83 Count
1790634019	32 Count	79 Count
1790632219	28 Count	75 Count
1790630418	24 Count	71 Count
1790628617	20 Count	67 Count
1790626817	16 Count	64 Count
1790625015	12 Count	59 Count
1790623214	9 Count	49 Count
1790621414	0 Count	1 Count
1790619622	477 Count	944 Count
1790617821	415 Count	795 Count
1790616020	329 Count	633 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)