APRS Track Direct

My position About ☰

reset

CR7BQX-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1751308435	277 Count	615 Count
1751308135	276 Count	614 Count
1751307834	275 Count	611 Count
1751307533	274 Count	610 Count
1751307233	273 Count	609 Count
1751306932	272 Count	606 Count
1751306632	271 Count	605 Count
1751306331	270 Count	603 Count
1751306031	269 Count	600 Count
1751305730	268 Count	599 Count
1751305429	267 Count	598 Count
1751305129	266 Count	595 Count
1751304828	265 Count	594 Count
1751304528	264 Count	593 Count
1751304227	263 Count	590 Count
1751303927	262 Count	589 Count
1751303626	261 Count	588 Count
1751303326	260 Count	585 Count
1751303025	259 Count	584 Count
1751302724	258 Count	582 Count
1751302424	257 Count	579 Count
1751302123	256 Count	576 Count
1751301862	251 Count	575 Count
1751301562	250 Count	573 Count
1751301261	249 Count	571 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)