APRS Track Direct

My position About ☰

reset

SP7K-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7K-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1758200077	67 Count	22 Count	5 Count
1758198276	66 Count	22 Count	5 Count
1758196475	65 Count	22 Count	5 Count
1758192874	63 Count	22 Count	5 Count
1758191073	62 Count	22 Count	5 Count
1758189272	61 Count	22 Count	5 Count
1758187482	60 Count	22 Count	5 Count
1758185681	59 Count	22 Count	5 Count
1758182125	55 Count	20 Count	3 Count
1758180278	54 Count	20 Count	3 Count
1758178477	53 Count	20 Count	3 Count
1758176676	52 Count	20 Count	3 Count
1758174875	51 Count	12 Count	3 Count
1758173075	48 Count	9 Count	1 Count
1758171274	47 Count	9 Count	1 Count
1758169473	46 Count	9 Count	1 Count
1758167672	45 Count	9 Count	1 Count
1758151153	43 Count	9 Count	1 Count
1758149371	42 Count	9 Count	1 Count
1758147570	41 Count	9 Count	1 Count
1758145770	40 Count	9 Count	1 Count
1758143969	39 Count	9 Count	1 Count
1758142168	38 Count	9 Count	1 Count
1758140367	37 Count	9 Count	1 Count
1758138566	36 Count	9 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)