APRS Track Direct

My position About ☰

reset

VA7OGO-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VA7OGO-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786730035	133	30	62	42	49
1786726387	133	28	61	42	49
1786724564	132	31	62	66	50
1786722741	130	65	60	43	49
1786720922	128	27	65	42	49
1786719098	127	30	67	42	49
1786715461	127	31	69	42	49
1786713632	126	36	70	42	49
1786709961	125	22	63	42	49
1786708115	126	29	69	42	49
1786704433	126	33	69	66	50
1786702599	126	27	69	42	49
1786700769	126	30	70	42	50
1786698950	126	31	69	42	49
1786697131	126	29	70	42	49
1786695313	126	30	69	42	49
1786693491	126	0	48	42	49
1786689852	127	28	67	42	49
1786688023	127	29	65	42	49
1786684358	127	31	66	42	49
1786682528	127	29	65	42	49
1786680696	128	30	65	42	49
1786678866	129	31	64	43	49
1786677051	130	30	63	42	49
1786675234	133	37	59	43	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)