APRS Track Direct

My position About ☰

reset

VE7RSS Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE7RSS. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732291453	137	137	73	43	123
1732290314	137	137	73	43	123
1732289173	136	137	73	43	123
1732288033	137	137	73	43	123
1732286893	137	137	73	43	123
1732285753	137	137	73	43	123
1732284613	136	137	73	43	123
1732283474	136	137	73	43	123
1732282333	132	136	72	43	122
1732281193	137	137	73	43	123
1732280053	136	137	73	43	123
1732278913	136	137	73	43	120
1732277776	136	137	73	43	124
1732276633	132	136	72	43	122
1732275493	136	137	73	43	123
1732274353	136	137	73	43	123
1732273214	137	137	73	43	123
1732272073	137	137	73	43	123
1732270933	136	137	73	43	123
1732269793	137	137	73	43	123
1732268653	137	137	73	43	123
1732267514	136	137	73	43	124
1732266373	137	137	73	43	123
1732265233	136	137	73	43	123
1732264092	137	137	73	43	123

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)