APRS Track Direct

My position About ☰

reset

CARSON Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CARSON. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274829	128	40	29	23	17
1836274290	128	39	28	23	17
1778063686	131	40	29	23	17
1778063145	131	41	29	23	17
1778062065	131	41	29	23	17
1778061525	131	41	29	23	17
1778060985	131	41	29	23	17
1778060445	131	41	29	23	17
1778059905	131	41	29	23	17
1778059366	131	41	29	23	17
1778058826	131	41	29	23	17
1778058285	131	40	29	23	17
1778057745	131	41	29	23	17
1778057206	131	40	29	23	17
1778056665	131	40	29	23	17
1778056125	131	40	29	23	17
1778055585	131	40	29	23	17
1778055045	131	40	29	23	17
1778054505	131	40	29	23	17
1778053965	131	41	29	23	15
1778053425	132	40	29	23	17
1778052885	131	40	29	23	17
1778052345	131	41	29	23	17
1778051805	131	41	29	23	17
1778051265	131	40	29	23	17

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)