APRS Track Direct

My position About ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786792122	31 Count	67 Count	29 Count
1786790317	19 Count	40 Count	18 Count
1786788512	7 Count	17 Count	7 Count
1786786707	576 Count	1022 Count	540 Count
1786784902	565 Count	998 Count	530 Count
1786783097	536 Count	956 Count	502 Count
1786781533	512 Count	909 Count	479 Count
1786779728	498 Count	879 Count	466 Count
1786777923	484 Count	853 Count	453 Count
1786776118	467 Count	823 Count	437 Count
1786774310	455 Count	801 Count	426 Count
1786772505	442 Count	779 Count	414 Count
1786770700	426 Count	756 Count	399 Count
1786768895	412 Count	734 Count	386 Count
1786767089	401 Count	714 Count	376 Count
1786765284	390 Count	696 Count	366 Count
1786763479	375 Count	674 Count	352 Count
1786761674	362 Count	655 Count	340 Count
1786759869	347 Count	631 Count	326 Count
1786758064	336 Count	612 Count	316 Count
1786756259	321 Count	584 Count	302 Count
1786754454	310 Count	562 Count	292 Count
1786752649	293 Count	537 Count	276 Count
1786750844	275 Count	509 Count	259 Count
1786749039	255 Count	477 Count	240 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)