APRS Track Direct

My position About ☰

reset

TA6EEB Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TA6EEB. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1754144314	-66 dBm	11.24 V
1754144115	-66 dBm	11.24 V
1754143312	-64 dBm	11.22 V
1754143181	-63 dBm	11.24 V
1754142377	-65 dBm	11.22 V
1754142251	-65 dBm	11.22 V
1754141447	-64 dBm	11.22 V
1754141320	-64 dBm	11.24 V
1754140516	-65 dBm	11.22 V
1754140388	-66 dBm	11.22 V
1754139585	-63 dBm	11.24 V
1754139457	-64 dBm	11.24 V
1754138653	-64 dBm	11.24 V
1754138525	-64 dBm	11.22 V
1754137722	-64 dBm	11.24 V
1754137592	-63 dBm	11.24 V
1754136789	-63 dBm	11.24 V
1754136659	-64 dBm	11.22 V
1754135855	-64 dBm	11.24 V
1754135727	-65 dBm	11.22 V
1754134923	-62 dBm	11.22 V
1754134793	-64 dBm	11.24 V
1754133994	-63 dBm	11.22 V
1754133860	-65 dBm	11.24 V
1754133056	-64 dBm	11.24 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)