APRS Track Direct

My position About ☰

reset

DL5BIT-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL5BIT-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	VBatt*	Temp*
1778024192	13.43 Volt	24.5 C
1778023292	13.43 Volt	24.5 C
1778022392	13.43 Volt	25 C
1778021492	13.43 Volt	25 C
1778020592	13.43 Volt	25.5 C
1778019692	13.43 Volt	25.5 C
1778018792	13.43 Volt	25.5 C
1778017892	13.43 Volt	26 C
1778016092	13.43 Volt	26.5 C
1778015192	13.43 Volt	26.5 C
1778014292	13.43 Volt	27 C
1778013392	13.43 Volt	27 C
1778012492	13.43 Volt	27.5 C
1778011592	13.43 Volt	27.5 C
1778010692	13.5 Volt	28 C
1778009792	13.5 Volt	28.5 C
1778008892	13.5 Volt	28.5 C
1778007992	13.5 Volt	29 C
1778007092	13.5 Volt	29.5 C
1778006192	13.58 Volt	30 C
1778005292	13.58 Volt	30.5 C
1778004392	13.65 Volt	31 C
1778001692	13.8 Volt	32.5 C
1778000792	13.8 Volt	33 C
1777999892	13.8 Volt	34 C

*Used Equation Coefficients:

VBatt: 0, 0.075, 0

Temp: 0, 0.5, -64

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)