APRS Track Direct

My position About ☰

reset

SP2SGK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762332919	400 Count	386 Count	195 Count
1762332017	398 Count	384 Count	194 Count
1762331114	396 Count	382 Count	193 Count
1762330210	394 Count	380 Count	192 Count
1762329308	392 Count	378 Count	191 Count
1762328405	390 Count	376 Count	190 Count
1762327501	388 Count	374 Count	189 Count
1762326598	386 Count	372 Count	188 Count
1762325695	384 Count	370 Count	187 Count
1762324793	382 Count	368 Count	186 Count
1762323889	380 Count	366 Count	185 Count
1762322987	378 Count	365 Count	184 Count
1762322084	376 Count	363 Count	183 Count
1762321181	374 Count	361 Count	182 Count
1762320278	372 Count	359 Count	181 Count
1762319375	370 Count	357 Count	180 Count
1762318472	368 Count	355 Count	179 Count
1762317569	366 Count	353 Count	178 Count
1762316666	364 Count	351 Count	177 Count
1762315838	363 Count	350 Count	177 Count
1762314935	361 Count	349 Count	176 Count
1762314032	359 Count	347 Count	175 Count
1762313129	357 Count	345 Count	174 Count
1762312226	355 Count	343 Count	173 Count
1762311323	353 Count	341 Count	172 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)