APRS Track Direct

My position About ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1836274793	111 Count	534 Count	106 Count
1836273893	90 Count	439 Count	86 Count
1762326519	94 Count	653 Count	84 Count
1762325618	79 Count	577 Count	70 Count
1762324717	66 Count	486 Count	58 Count
1762323816	57 Count	422 Count	50 Count
1762322915	39 Count	309 Count	34 Count
1762322014	32 Count	243 Count	28 Count
1762321113	21 Count	155 Count	18 Count
1762320212	5 Count	51 Count	4 Count
1762319312	4 Count	49 Count	4 Count
1762318411	134 Count	1008 Count	118 Count
1762317510	126 Count	945 Count	111 Count
1762316609	120 Count	900 Count	106 Count
1762315708	106 Count	777 Count	94 Count
1762314807	98 Count	709 Count	87 Count
1762313906	87 Count	641 Count	77 Count
1762313005	80 Count	591 Count	71 Count
1762312104	66 Count	456 Count	59 Count
1762311203	63 Count	425 Count	57 Count
1762310302	54 Count	366 Count	49 Count
1762309401	46 Count	319 Count	42 Count
1762308500	30 Count	202 Count	27 Count
1762307599	13 Count	90 Count	12 Count
1762306698	6 Count	43 Count	6 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)