APRS Track Direct

My position About ☰

reset

XE1DGC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE1DGC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274191	134	24	999	379	279
1774148755	132	22	999	385	285
1774145193	132	23	999	382	283
1774141631	132	23	999	380	282
1774138069	133	23	999	381	282
1774134506	132	23	999	383	284
1774130944	132	22	999	386	286
1774127382	132	21	999	390	291
1774123820	133	20	999	394	295
1774120258	133	20	999	397	298
1774116695	133	19	999	400	301
1774113133	133	18	999	403	304
1774109571	132	18	999	402	303
1774106009	132	18	999	402	303
1774102447	132	18	999	402	303
1774098885	132	19	999	401	302
1774095323	132	19	999	400	301
1774091760	132	19	999	400	300
1774088198	132	20	999	396	297
1774084636	132	19	999	397	298
1774081074	132	20	999	396	297
1774077511	117	20	999	394	294
1774073948	132	21	999	390	291
1774070385	132	21	999	389	289
1774066823	132	22	999	387	287

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)