APRS Track Direct

My position About ☰

reset

W1FN-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W1FN-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1749325730	133	84	136	117	114
1749322133	141	84	137	117	114
1749320335	140	83	137	117	114
1749316738	140	83	137	118	114
1749314938	137	83	137	118	114
1749313139	134	82	137	117	114
1749311342	133	82	137	118	115
1749309544	133	82	137	118	115
1749305947	132	83	137	117	114
1749304149	132	84	136	117	114
1749302351	132	84	136	117	114
1749300552	133	84	136	117	114
1749298754	132	84	136	117	114
1749296956	133	84	136	117	114
1749295158	132	83	136	117	113
1749293358	132	82	137	118	113
1749291559	131	82	136	118	113
1749289761	131	82	137	118	113
1749287962	131	82	136	118	113
1749286162	131	82	137	118	113
1749275362	131	83	137	117	112
1749269968	131	84	137	117	112
1749268170	131	84	137	117	112
1749266372	131	84	137	117	112
1749262776	131	85	137	117	112

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)