APRS Track Direct

My position About ☰

reset

ED1YBD-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED1YBD-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1754108135	37	18	72	191	154
1754107233	35	17	72	191	154
1754106336	36	17	72	191	154
1754105431	36	17	72	191	154
1754104530	36	17	72	191	155
1754103630	33	15	72	191	155
1754102729	33	15	72	191	154
1754101828	35	15	72	191	154
1754100927	38	16	73	191	154
1754100026	40	18	73	191	154
1754099125	44	19	73	191	154
1754098225	42	19	73	191	154
1754097324	41	18	73	191	155
1754096423	43	18	73	191	155
1754095522	42	17	73	191	155
1754094621	44	17	73	191	155
1754093720	43	17	73	191	154
1754092819	43	16	73	191	156
1754091918	41	16	73	191	155
1754091019	39	16	73	191	155
1754090118	42	17	73	191	155
1754089216	41	17	73	191	155
1754088315	40	17	73	191	156
1754087414	40	18	73	191	156
1754086513	38	16	73	191	156

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)