APRS Track Direct

My position About ☰

reset

EA1BVF-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA1BVF-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274149	90	1	78	129	159
1762313911	63	2	79	172	148
1762312709	65	1	79	172	148
1762311508	70	1	79	172	148
1762310307	71	1	79	172	148
1762309106	73	2	79	172	149
1762307905	68	2	79	173	148
1762306704	64	2	79	173	149
1762305503	60	1	79	173	149
1762304301	62	1	79	173	149
1762303100	63	2	79	173	149
1762301899	63	2	79	173	149
1762300698	62	2	79	174	148
1762299498	61	1	79	174	148
1762298296	61	1	79	174	148
1762297094	61	2	79	174	148
1762295893	62	2	79	174	148
1762294692	62	2	79	175	148
1762293491	62	2	79	175	148
1762292290	62	2	79	175	148
1762291089	63	2	79	175	148
1762289888	64	1	79	176	148
1762288687	66	2	79	176	148
1762287486	64	2	79	176	148
1762286285	67	2	79	176	148

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)