APRS Track Direct

My position About ☰

reset

SR8MBR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8MBR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790637587	30 Count	35 Count
1790635786	728 Count	1004 Count
1790633985	670 Count	936 Count
1790632185	613 Count	848 Count
1790630384	582 Count	812 Count
1790628583	552 Count	780 Count
1790626783	517 Count	740 Count
1790624989	484 Count	710 Count
1790623188	427 Count	654 Count
1790621387	384 Count	614 Count
1790619586	317 Count	558 Count
1790617786	266 Count	496 Count
1790615985	222 Count	456 Count
1790614184	163 Count	390 Count
1790612384	120 Count	328 Count
1790610583	87 Count	287 Count
1790608782	43 Count	185 Count
1790606982	339 Count	1129 Count
1790605181	305 Count	955 Count
1790603388	263 Count	820 Count
1790601588	198 Count	632 Count
1790599787	128 Count	429 Count
1790597986	60 Count	213 Count
1790596186	327 Count	1115 Count
1790594385	278 Count	951 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)