APRS Track Direct

My position About ☰

reset

PE1PNX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PNX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1758222882	181 Count	144 Count	31 Count
1758221078	180 Count	144 Count	31 Count
1758219275	179 Count	144 Count	31 Count
1758217471	178 Count	143 Count	31 Count
1758215708	173 Count	143 Count	31 Count
1758213905	172 Count	143 Count	31 Count
1758212101	171 Count	143 Count	31 Count
1758210297	170 Count	143 Count	31 Count
1758208494	169 Count	142 Count	31 Count
1758206690	168 Count	141 Count	31 Count
1758204886	167 Count	139 Count	31 Count
1758203082	166 Count	138 Count	31 Count
1758201279	165 Count	138 Count	31 Count
1758199476	158 Count	132 Count	25 Count
1758197671	132 Count	107 Count	0 Count
1758195868	131 Count	107 Count	0 Count
1758194105	126 Count	107 Count	0 Count
1758192302	125 Count	107 Count	0 Count
1758190498	124 Count	107 Count	0 Count
1758188694	123 Count	107 Count	0 Count
1758186891	122 Count	107 Count	0 Count
1758185087	121 Count	106 Count	0 Count
1758183283	120 Count	106 Count	0 Count
1758181480	119 Count	106 Count	0 Count
1758179676	118 Count	105 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)