APRS Track Direct

My position About ☰

reset

TA5LVC-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TA5LVC-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1786895181	-54 dBm	3.3 V
1786894581	-53 dBm	3.3 V
1786893981	-54 dBm	3.3 V
1786893381	-54 dBm	3.3 V
1786892781	-53 dBm	3.3 V
1786892181	-53 dBm	3.3 V
1786891581	-54 dBm	3.3 V
1786890981	-52 dBm	3.3 V
1786890381	-54 dBm	3.3 V
1786889782	-53 dBm	3.3 V
1786889181	-60 dBm	3.3 V
1786888581	-54 dBm	3.3 V
1786887981	-53 dBm	3.3 V
1786887381	-54 dBm	3.3 V
1786886781	-54 dBm	3.3 V
1786886180	-54 dBm	3.3 V
1786885580	-54 dBm	3.3 V
1786884980	-53 dBm	3.3 V
1786884381	-54 dBm	3.3 V
1786883780	-54 dBm	3.3 V
1786883180	-54 dBm	3.3 V
1786878098	-56 dBm	3.3 V
1786878080	-55 dBm	3.3 V
1786877480	-54 dBm	3.3 V
1786876880	-55 dBm	3.3 V

*Used Equation Coefficients:

RxPackets: 0, 1, 0

TxPackets: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, 1, -200

Voltage: 0, 0.1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)