APRS Track Direct

My position About ☰

reset

IT9IRS-TP Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-TP. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791754677	86 Count	139 Count	29 Count
1791754432	84 Count	137 Count	28 Count
1791754188	83 Count	136 Count	28 Count
1791753944	81 Count	131 Count	27 Count
1791753699	79 Count	128 Count	26 Count
1791753455	78 Count	126 Count	26 Count
1791753211	76 Count	124 Count	25 Count
1791752966	75 Count	123 Count	25 Count
1791752722	73 Count	120 Count	24 Count
1791752478	72 Count	111 Count	24 Count
1791752233	69 Count	107 Count	22 Count
1791751989	68 Count	105 Count	22 Count
1791751744	66 Count	103 Count	21 Count
1791751500	65 Count	102 Count	21 Count
1791751255	63 Count	100 Count	20 Count
1791751011	62 Count	97 Count	20 Count
1791750767	61 Count	95 Count	20 Count
1791750523	60 Count	94 Count	20 Count
1791750278	59 Count	90 Count	20 Count
1791750034	57 Count	87 Count	19 Count
1791749789	56 Count	86 Count	19 Count
1791749545	54 Count	84 Count	18 Count
1791749301	53 Count	82 Count	18 Count
1791749056	51 Count	77 Count	17 Count
1791748812	50 Count	74 Count	17 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)