APRS Track Direct

My position About ☰

reset

ACARC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ACARC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790638029	140	164	255	79	70
1790634426	140	164	255	79	71
1790630823	140	164	255	80	72
1790627220	140	163	255	81	73
1790623617	140	163	255	82	74
1790620015	140	162	255	84	77
1790616412	140	161	255	86	81
1790612809	140	159	255	90	86
1790609206	139	156	255	96	95
1790605604	139	155	255	99	99
1790602001	139	155	255	99	99
1790598398	139	155	255	98	98
1790594794	139	155	255	98	98
1790591192	139	155	255	98	97
1790587589	139	156	255	97	96
1790583986	139	156	255	96	96
1790580384	139	156	255	95	94
1790576781	139	157	255	94	92
1790573178	140	158	255	93	90
1790569575	140	158	255	91	88
1790565972	140	160	255	88	84
1790562370	140	161	255	85	79
1790558767	140	163	255	81	73
1790555164	140	165	255	77	67

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)