APRS Track Direct

My position About ☰

reset

YB8VRA-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YB8VRA-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1836274708	-23 dBm	0.04 V
1836274386	-22 dBm	0.04 V
1836274280	-23 dBm	0.02 V
1836274063	-23 dBm	0.04 V
1763663136	-43 dBm	0.02 V
1763662814	-44 dBm	0.04 V
1763662492	-45 dBm	0.06 V
1763662057	-42 dBm	0.04 V
1763661735	-45 dBm	0.02 V
1763661413	-43 dBm	0.02 V
1763661091	-44 dBm	0.02 V
1763660780	-46 dBm	0.02 V
1763660484	-44 dBm	0.02 V
1763660245	-43 dBm	0.04 V
1763659840	-44 dBm	0.04 V
1763659518	-45 dBm	0.02 V
1763659196	-43 dBm	0.04 V
1763658874	-50 dBm	0.04 V
1763658717	-43 dBm	0.02 V
1763658395	-41 dBm	0.04 V
1763658073	-44 dBm	0.04 V
1763657909	-44 dBm	0.04 V
1763657712	-42 dBm	0.04 V
1763657390	-44 dBm	0.04 V
1763657208	-46 dBm	0.02 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)