APRS Track Direct

My position About ☰

reset

TABNSH Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TABNSH. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1782495390	142	31	63	42	48
1782494778	142	25	62	42	48
1782494158	139	33	62	42	49
1782493549	143	27	61	42	49
1782492939	142	29	63	42	49
1782492324	139	34	60	42	49
1782491706	142	29	63	42	49
1782491098	142	26	63	42	48
1782490486	143	28	91	43	75
1782489873	140	36	63	42	50
1782489261	140	26	63	42	48
1782488649	137	29	61	42	49
1782488033	137	81	59	42	49
1782446163	122	32	69	42	48
1782445545	124	29	69	42	49
1782444928	125	28	70	42	49
1782444312	124	67	63	42	49
1782443695	125	24	69	42	49
1782443079	126	33	69	68	50
1782442467	126	26	69	42	49
1782441855	126	36	68	42	49
1782441243	126	26	68	42	50
1782440634	126	29	69	42	49
1782440028	126	25	68	42	48
1782439414	126	25	68	42	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)