APRS Track Direct

My position About ☰

reset

EA4IAX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4IAX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1791982520	86 Count	780 Count
1791978917	81 Count	731 Count
1791975314	76 Count	691 Count
1791971711	71 Count	651 Count
1791968108	66 Count	611 Count
1791964505	62 Count	573 Count
1791960902	57 Count	534 Count
1791957299	52 Count	496 Count
1791953699	47 Count	450 Count
1791950131	42 Count	391 Count
1791946527	32 Count	340 Count
1791942925	27 Count	298 Count
1791939322	22 Count	235 Count
1791935719	17 Count	174 Count
1791932116	12 Count	111 Count
1791928513	4 Count	46 Count
1791924910	486 Count	1006 Count
1791921307	481 Count	954 Count
1791917704	476 Count	910 Count
1791914101	447 Count	863 Count
1791910498	319 Count	829 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)